talk about general wheeling tech(i.e wheels, axles,tires also for tech articals )
By pineappletuna
#11385
Anyone have any experience with a old mw pump dr 466 I just bought truck with one and I am wondering about easy cheap ways to turn it up gonna do a inframe rebuild on it to start and I have found some stuff online about how to turn up the fuel screw and stuff also found a recommendation for a holset hx40 turbo but I can't find too much info on what all it takes to install it and I haven't messed with a grease burner for years
By pineappletuna
#11418
The new crawler hauler that I'm needing the bigger ponies for
Attachments:
image.jpg
image.jpg (12.9 KiB) Viewed 2726 times
User avatar
By axleater
#11419
Sweet!
By pineappletuna
#12472
I thought I would follow up on this in case anyone ever goes this direction again
I ended up with a Borg Warner S366 turbo and a mishimoto air to air intercooler and the fuel pump turned up 8 turns and I turned up the pre boost fuel 3 clicks also added a boost gauge and pyrometer and now it will pull quite well it will run the egts high under full load in the summer but in the winter it stays cool enough so you have to drive it by the gauges but it will handle the loads I put on it now and it will roll coal :-D
By pineappletuna
#12473
This is how it looks running down the road now
Attachments:
image.jpg
image.jpg (16.62 KiB) Viewed 2188 times
User avatar
By axleater
#12478
How does it go down the road?
By pineappletuna
#12480
It will run 70 on flat ground loaded pulling around the hills it can be a lot of work with the two trans to shift but who wouldn't want twin sticks in there hauler too

I Developed an annoying " transfercase full o[…]

Gun Run

Meeting at the gaslight in Rockerville, 9 am Satur[…]

Fall colors run

Robbie has agreed to take us on an epic tour of fa[…]

Columbus Montana race

just a week and a half before the columbus race Se[…]